Remove a spring lock ring And, holding the bearing.

Fig. 3.97. Vypressovka of the bearing by means of the plug

Vypressuyte the bearing by means of the plug with a diameter of 50 mm in a case (fig. 3.97).

Fig. 3.98. Installation of the bearing by means of the plug

Install the bearing by means of the plug with a diameter of 65 mm. The separator of the bearing has to be sent to the opposite side from the conducted gear wheel (fig. 3.98).

Establish the spring lock ring holding the bearing.

Again establish differential in a case. Establish wooden whetstone under a gear wheel.

Establish a spring lock ring In on a head of 1 adaptation (B.Vi.946), and then a head – on planetary transfer.

Fig. 3.99. Installation of the spring lock ring holding the bearing: 1 – head of adaptation (B.Vi.946); 2 – adaptation (B.Vi.946)

Install adaptation 2 (B.Vi.946) on a head and insert with effort until the spring lock ring does not rise on the place. Remove adaptation (B.Vi.946) (fig. 3.99).

Turn all assembly, and check whether the leading gear wheel of a speedometer rotates (if it is established).