49909390

3.11.3. Removal, replacement and installation of an epiploon of differential (JH3, JR5)

Removal
Install the car on the two-rack-mount elevator.
Disconnect wires from plugs of the rechargeable battery, since the minus plug.
Remove protection of the pallet of a case of the engine.
Merge oil from the transmission.
Remove:
– wheel;
– antisplash guard;
– nave nut;
– spherical hinge of a tip of steering draft;
– spherical hinge of a rack of the stabilizer of cross stability;
– spherical support of the lever of a suspension bracket.
Disconnect:
– a block of wires from the sensor of speed of rotation of a wheel;
– conducting of sensors of the proofreader of headlights with xenon lamps (if they are established).

Fig. 3.37. Flange of an intermediate support


Remove a flange of an intermediate support (fig. 3.37).

Fig. 3.38. Removal of a shaft of the drive


Remove a shaft of the drive of a wheel (fig. 3.38).

Replacement of an epiploon
Tap an epiploon on the basis by means of a drift and the small hammer so that the epiploon was turned in a nest.
Then remove it nippers, trying not to damage at the same time vents of a semi-axial gear wheel.

Installation

Fig. 3.39. New epiploon of differential


Oil a new epiploon (fig. 3.39).
Press a new epiploon by means of a mandrel (Bvi. 1666) (index A: for the right side, an index B: for the left side).
Arrange a wheel drive shaft before a semi-axial gear wheel.
Installation is made as it should be, the return to removal.
Tighten the required moment:
– bolts of fastening of a wheel (110 N · l);
– nut of fastening of a finger of a spherical support of the lever of a suspension bracket (62 N · l);
– nut of fastening of a finger of the spherical hinge of a tip of steering draft (37 N · l);
– nut of fastening of a finger of the spherical hinge of the stabilizer of cross stability (44 N · l);
– nave nut (280 N · l);
– nut of a flange of an intermediate support of a shaft of the drive of a wheel (21 N · l);
– bolts of fastening of jet thirst for the engine (180 N · l);
– bolts of fastening of jet thirst for a stretcher (105 N · м).
Fill in oil in the transmission.
Connect the rechargeable battery.