Removal

Disconnect wires from plugs of the rechargeable battery, since the minus plug.

Fig. 3.6. Removal of an air duct: 1 – air duct

Remove the left lower casing and an air duct (fig. 3.6).

Remove the sensor of the beginning of the course of gray color, having turned it on a quarter of a turn.

Fig. 3.7. Removal of a pedal of coupling: 1 – sensor of the beginning of the course of gray color; 2 – sensor of the end of the course of green color; 3 – spherical head of the main cylinder; 4 – nuts of fastening of a plate

Disconnect a block of wires from the sensor (fig. 3.7).

Remove the sensor of the beginning of the course of gray color, having turned it on a quarter of a turn.

Disconnect a block of wires from the sensor.

Remove the sensor of the end of the course of green color, having turned it on a quarter of a turn.

Disconnect a block of wires from the sensor.

Disconnect a spherical head of the main cylinder from a coupling pedal.

Separate the coupling pedal course sensor socket.

Remove the coupling pedal course sensor.

Remove three nuts of fastening of a plate of knot of a pedal of coupling.

Take coupling pedal knot.

Installation is made as it should be, the return to removal.

Tighten nuts of fastening of a plate of knot of a pedal of coupling the moment (21 N · м).

Surely pull for rods of sensors to choose an adjusting gap.

Sensors of the course of a pedal of coupling are automatically adjusted depending on the provision of a pedal.

Fig. 3.8. Installation of the sensor of the course of coupling

Install sensors in their nests (fig. 3.8).

Turn the sensor on a quarter of a turn clockwise.

Connect sockets of sensors of a pedal of coupling.