3.12.8.3. The works performed on the right side of the car
Turn off a nave nut by means of adaptation (Rou. 604-01).
Remove the spherical hinge of a tip of steering draft, using adaptation (Tav. 476).
Remove the spherical hinge of a rack of the stabilizer of cross stability by means of adaptation (Tav. 476).
Remove a spherical support of the lever of a suspension bracket.
Remove a flange of an intermediate support.
Fig. 3.154. A detachment of a power shaft from a rotary fist
|
Disconnect a power shaft from a rotary fist (fig. 3.154).
Remove a shaft of the drive of the right forward wheel.
Fix an engine cooling system radiator assembled with the condenser on the top cross-piece by means of a cord.
Remove the side amplifier.
Fig. 3.155. Removal of the lower cross-piece of a radiator
|
Remove the lower cross-piece of a radiator (fig. 3.155).
Двигатеь K4M.
Fig. 3.156. Removal of jet draft: 1 – nuts of fastening of the final pipeline
|
Turn off nuts of fastening of the final pipeline and remove jet draft (fig. 3.156).
F4R engine.
Fig. 3.157. Removal of jet draft: 1 – nuts of fastening of the final pipeline; 2 – jet draft
|
Turn off nuts of fastening of the final pipeline and remove jet draft (fig. 3.157).
Remove a strut of fastening of a collector to the lower part of the engine.
Fig. 3.158. Removal of a starter: 1 – bolt of fastening of a starter
|
Turn off a bolt of fastening and remove a starter (fig. 3.158).
Turn off three nuts of fastening of the hydrotransformer.
NOTE
Access to nuts of fastening of the hydrotransformer opens after removal of a starter. Turn a bent shaft clockwise so that to get access to three nuts connecting a drive plate to the hydrotransformer.
|
Fig. 3.159. Removal of the top hairpins of fastening of a case of the transmission: 1 – hairpins
|
Remove the top hairpins of fastening of a case of the transmission to the block of the engine (fig. 3.159).
Record a cowl belts.
Remove a transmission support pillow.
Establish a hydraulic jack under the transmission.
Turn off the lower bolts of fastening of the transmission to the engine block.
Remove hairpins of fastening of the transmission.
Remove the automatic transmission.
Fig. 3.160. Fixing of the hydrotransformer
|
Fix the hydrotransformer by means of a cord to warn him the shift (fig. 3.160).