Install the car on the two-rack-mount elevator.

Remove the top covers of the engine.

Disconnect wires from plugs of the rechargeable battery, since the minus plug.

Remove:

– airintaking branch pipe;

– rechargeable battery;

– to a regiment under the rechargeable battery;

– EBU of system of injection together with an arm;

– inlet air duct;

– fastenings of a plait of wires.

Remove a spherical tip of a cable of the multipurpose switch by means of adaptation and a cable.

Disconnect a block of wires from the sensor of speed of the movement, a block of wires, having released a mobile part of the socket and turn off bolts of fastening of an arm of the modular socket.

ATTENTION Protect the socket, having placed it in a waterproof plastic package.

Fig. 3.149. Sensor of frequency of rotation of a bent shaft of the K4M engine

Remove the sensor of frequency of rotation of a bent shaft of the engine (fig. 3.149 and 3.150).

Fig. 3.150. Sensor of frequency of rotation of a bent shaft of the F4R engine

Press hoses clips.

Disconnect hoses from a cooler.

Remove a plait of wires from the transmission.

Fig. 3.151. Bolts of fastening of a starter: 1 – bolts

Turn off two bolts of fastening of a starter and remove protection of the pallet of a case of the engine (fig. 3.151).

Merge oil from the transmission.

Remove wheels and flaps.

Disconnect wires from ABS sensors and a wire from sensors of the proofreader of xenon headlights (if they are established).

NOTE The sensor of the proofreader of xenon headlights is located on the left lever of a suspension bracket.