3.12.13. Removal and installation of sensors of speed of the movement of the car and speed of rotation of the turbine of the hydrotransformer
Removal
Install the car on the two-rack-mount elevator.
Remove the top covers of the engine.
Disconnect wires from plugs of the rechargeable battery, since the minus plug.
|
Fig. 3.166. Sensor of speed of rotation of the turbine of the hydrotransformer
|
|
NOTE
For removal of sensors with a scab of rotation of the turbine of the hydrotransformer and speed of the movement it is not required to merge oil and to remove the automatic transmission.
When replacing the sensor surely remove the modular socket.
|
Remove protection of the pallet of the engine.
|
Fig. 3.167. Removal of the socket
|
Take out the socket shown by an arrow in the figure 3.167 from a transmission arm.
|
Fig. 3.168. Location of the sensor of speed of rotation of the turbine of the hydrotransformer
|
Remove the sensor of speed of rotation of the turbine of the hydrotransformer (fig. 3.168).
|
ATTENTION
Protect the socket from damages, having packed it into a waterproof plastic package.
|
Removal of the sensor
speeds of the movement
|
Fig. 3.169. Socket of the sensor of speed of the movement
|
Separate the socket of the sensor (fig. 3.169).
|
Fig. 3.170. Location of the sensor of speed of the movement
|
Remove the sensor of speed of the movement (fig. 3.170).
Installation
Installation is made as it should be, the return to removal.
Tighten the required moment:
– bolt of fastening of the sensor of speed of rotation of the turbine of the hydrotransformer (10 N · l);
– bolt of fastening of the sensor of speed of the movement (44 N · м).