Install the car on the two-rack-mount elevator.

Fig. 6.53. Removal of a rug of the tsetralny console: 1 – rug

Remove a rug of the central console (fig. 6.53).

Fig. 6.54. Removal of the central console: 1 – fastening screws

Turn off screws of fastening of the central console and remove its (fig. 6.54).

Fig. 6.55. A detachment of cables of the drive of the parking brake in a drive lever zone: 1 – regul rovochny nut; 2 – drive cables

Turn off an adjusting nut, disconnect cables of the drive of the parking brake in a zone of the lever of the drive (fig. 6.55).

Move cables of the drive of the parking brake into covers.

Lift the car.

Fig. 6.56. Drawing of a cable from below car

Pull on yourself cables of the drive of the parking brake from below of the car (fig. 6.56).

Remember the route of laying of a cable for the subsequent installation.

Disconnect cables of the drive of the parking brake from brackets of brakes and from guides.

Fig. 6.57. Extraction of a cable from a back suspension bracket

Take cables of the drive of the parking brake from a back suspension bracket (fig. 6.57).

Remove cables of the drive of the parking brake.

At installation lay conducting on the former route.

Installation is made as it should be, the return to removal.

Fig. 6.58. Installation of an adjusting nut

Screw an adjusting nut so that to receive the size X equal to 17 mm (fig. 6.58).

Tighten an adjusting nut so that brake shoes slightly concerned brake disks.

Check the size of the course of the lever of the drive of the parking brake.

Establish:

– central console;

– screws of fastening of the central console;

– rug of the central console.

Tighten the required moment:

– bolts of fastening of the lever of the drive of the parking brake (8 N · l);

– screws of fastening of the central console (2 N · м).