NOTE When checking a gap do not turn a bent shaft at all.

Remove the oil remains from radical necks and support of the block of cylinders.

Establish a bent shaft and persistent half rings of a bent shaft on the 3rd support (flutes to cheeks of a bent shaft).

Cut several pieces of the calibrated wire.

Put a wire on an axis of radical necks of a bent shaft (out of a zone of an arrangement of openings for lubricant of support).

Establish covers of radical bearings of a bent shaft, having arranged a cover 1 from a flywheel.

Fig. 2.149. Order zatyagivagiya of bolts of fastening of covers of radical bearings of a bent shaft

Tighten in that order the required moment (25 N · m + 47 ° ±5 °) also tighten on the required corner bolts of fastening of covers of radical bearings of a bent shaft (see fig. 2.149).

Uncover radical bearings and a bent shaft.

On flattening of the calibrated wire define a gap between inserts and radical necks by the scale put on packing.

Check the gap size which has to make 0,027–0,054 mm.

Clear a bent shaft and inserts of radical bearings of the remains of the calibrated wire.

Fig. 2.165. Check of a diametrical gap radical necks of a bent shaft and bearings by means of a calibration wire: 1 – calibration wire; 2 – scale