2.4.1.11. Correction of frequency of rotation of idling depending on temperature of cooling liquid (K4M engine)
* Except a case of start of the engine at a temperature of 15-30 °C.
- 1. Operation and maintenance of the car
- 2. Engine
- 2.1. General procedures of technical service
- 2.2. Mechanical part of the engine
- 2.3. Fuel system
- 2.4. System of injection
- 2.4.1. Features of system of multipoint injection of SAGEM "S3000"
- 2.4.1.1. EBU with 128 contacts
- 2.4.1.2. Maximum frequency of rotation of a bent shaft
- 2.4.1.3. Camshaft phase-shifter
- 2.4.1.4. Principle of action of alarm lamps
- 2.4.1.5. Communication between EBU of system of injection and EBU of climatic installation
- 2.4.1.6. Algorithm of turning on of the compressor of the conditioner
- 2.4.1.7. Principle of operation of the block of a butterfly valve
- 2.4.1.8. Standby mode of the block of a butterfly valve
- 2.4.1.9. Correction of frequency of rotation of idling depending on temperature of cooling liquid (F4R engine)
- 2.4.1.10. Correction of frequency of rotation of idling depending on temperature of cooling liquid (K4J engine)
- 2.4.1.11. Correction of frequency of rotation of idling depending on temperature of cooling liquid (K4M engine)
- 2.4.1.12. Correction of frequency of rotation of idling depending on tension of the rechargeable battery and balance of electric energy
- 2.4.1.13. Correction of frequency of rotation of idling at malfunction of the sensor of absolute pressure
- 2.4.2. Regulation of composition of fuel mix (F4R, K4M engines)
- 2.4.3. Camshaft phase-shifter (F4R, K4M engines)
- 2.4.4. Removal and installation of oxygen sensors (all engines)
- 2.4.5. Removal and installation of the sensor of provision of a pedal of an accelerator (all engines)
- 2.4.6. Sensor of situation and frequency of rotation of a bent shaft of the engine (all engines)
- 2.4.7. Removal and EBU installation of system of injection of the petrol engine (all engines)
- 2.4.8. Removal and installation of the block of a butterfly valve (K4J engine)
- 2.4.9. Removal and installation of the block of a butterfly valve (K4M engine)
- 2.4.10. Removal and installation of the block of a butterfly valve (F4R engine)
- 2.4.11. Cleaning of the block of a butterfly valve (all engines)
- 2.4.1. Features of system of multipoint injection of SAGEM "S3000"
- 2.5. System of an admission and release
- 2.6. System of start and charging
- 2.7. Cooling system
- 2.8. System of decrease in toxicity
- 2.9. System of production of the fulfilled gases
- 2.10. Appendix 1
- 2.11. Appendix 2
- 2.12. Tables
- 3. Transmission
- 4. Running gear
- 5. Steering mechanism
- 6. Brake system
- 7. Onboard electric equipment
- 8. Body
- 9. Schemes of electric equipment
