The sensor of situation forms one knot with an accelerator pedal. Together with the sensor it is necessary to replace also a pedal of an accelerator.

On the car the pedal of an accelerator of two types can be established: with the switch at the end of the course or without it.

Install an accelerator pedal with the switch at the end of the course on the cars equipped with the speed regulator / limiter Kik-Down.

The switch serves for cancellation of the mode of restriction of speed if the driver needs to increase it.

ATTENTION Installation of a pedal with the switch at the end of the course instead of a pedal without switch is possible. It is forbidden to establish a pedal without switch instead of a pedal with the switch.

Fig. 2.233. Accelerator pedal

Disconnect wires from plugs from the rechargeable battery, since the negative plug, and a block of wires of the sensor of provision of a pedal of an accelerator.

Turn off bolts of fastening of a pedal and remove a pedal.

Installation is made as it should be, the return to removal.

Attach wires to plugs of the rechargeable battery, since the plus plug.

NOTE Malfunction of the sensor of provision of a pedal of an accelerator causes change of operation of the engine idling or on the load modes.