Disconnect wires from plugs of the rechargeable battery, since the minus plug.

Remove an inlet collector.

ATTENTION Be careful of emissions of gasoline at a detachment of the bringing fuel-supply line from a toplivoraspredelitelny stage.

Fig. 2.205. Detachment of a block of wires of fuel nozzles and untwisting of bolts of fastening of a toplivoraspredelitelny stage: 1 – blocks of wires of nozzles; 2 – bolts of fastening of a toplivoraspredelitelny stage

Disconnect blocks of wires from nozzles, turn off a plait of wires aside and turn off bolts of fastening of a toplivoraspredelitelny stage (fig. 2.205).

Remove a toplivoraspredelitelny stage, having carefully pulled it on themselves.

Fig. 2.206. Otvorachivaniye of bolts of fastening of a lining of cases of nozzles: 1 – fastening bolts

Turn off bolts of fastening of a lining of cases of nozzles (fig. 2.206).

Laying of a lining of cases of nozzles is subject to obligatory replacement.

Establish all bolts of fastening.

Apply:

– a lining of cases of nozzles to the top cover of the GRM drive, having wrapped a bolt And by hand.

– a lining of cases of nozzles to a support of a pendular engine mount, having tightened a bolt In by hand.

Fig. 2.207. Installation of new laying of cases of nozzles

Tighten in the order shown in the figure 2.207 the required moment:

– bolts of the 5 and 6 fastening of a lining of cases of nozzles (25 N · l);

– bolts of the 7 and 14 fastening of a lining of cases of nozzles (21 N · м).

Tighten the required moment:

bolt of fastening of a support of a pendular suspension bracket (44 N · l);

– bolt of fastening of the top cover of the GRM drive (44 N · м).

Establish an inlet collector.

Installation is made as it should be, the return to removal.

Attach wires to plugs of the rechargeable battery, since the plus plug.