Install the car on the two-rack-mount elevator.

Disconnect the rechargeable battery.

Simite rechargeable battery.

Remove the right forward wheel.

Remove the right forward flap.

Remove the top covers of the engine.

Install devices (Mot. 1453) and (Mot. 1453-01) with the holding belts.

Fig. 2.54. Removal of the right side amplifier of a cross-piece of a frame of a radiator: 1 – amplifier

Remove the right side amplifier of a cross-piece of a frame of a radiator and the lower jet draft (fig. 2.54).

Separate sockets, disconnect a cowl lock drive cable.

Remove the holder.

Fig. 2.55. Removal of a bypass roller by means of special adaptation: 1 – sockets; 2 – cowl lock drive cable; 3 – holder; 4 – bolt of fastening of a bumper

Turn off a bolt of fastening and remove a front bumper (fig. 2.55).

Disconnect windscreen washer tubes.

Fig. 2.56. Removal of a bypass roller by means of special adaptation: 1 – fastening bolts

Turn off bolts of fastening of the forward panel of a body (fig. 2.56)

Remove the forward panel of a body.

Remove a shaft of the drive of the right forward wheel.

Fig. 2.57. Installation of adaptation with fixing belts

Install adaptation (Mot. 1672) with fixing belts (fig. 2.57).

Fig. 2.58. Marking of support of a pendular suspension bracket

Note the provision of a support of a pendular suspension bracket concerning a body (fig. 2.58).

Remove a support of a pendular suspension bracket.

NOTE Take measures not to deform the pipeline of the air conditioning system. Take off a belt of the drive of auxiliary units.

Fig. 2.59. Removal of the taking-away air duct of the air filter and the block of a butterfly valve: 1 – the taking-away air duct of the air filter; 2 – block of a butterfly valve

Remove the taking-away air duct of the air filter, the block of a butterfly valve and a block of wires from a lifting eye (fig. 2.59).

Fig. 2.60. Removal of the electromagnetic valve of a purge of an adsorber: 1 – electromagnetic valve

Remove the electromagnetic valve of a purge of an adsorber (fig. 2.60).

Fig. 2.61. Release of the water electric pump: 1 – fastening nut; 2 – water electric pump

Turn off a nut, pull for a rack of fastening of the water electric pump and take him aside (fig. 2.61).

Fig. 2.62. Removal of a stopper of an opening under VMT clamp: 1 – stopper

Turn out a stopper from an opening under a clamp of VMT (fig. 2.62).

Fig. 2.63. Caps of camshafts

Remove caps of camshafts (fig. 2.63).