NOTE At removal remember colors of marking of shock-absorbers and springs not to mix them at installation.

Install the car on the two-rack-mount elevator.

Remove back wheels.

Establish a hydraulic jack and put linings, rest a jack against a cup of the right spring, without squeezing a spring.

Note the provision of a spring.

Fig. 4.38. Removal of the lower fastening of the shock-absorber: 1 – bolt of the lower fastening of the shock-absorber

Turn off a bolt of the lower fastening of the shock-absorber (fig. 4.38).

Remove a hydraulic jack.

Fig. 4.39. Removal of a spring of the back shock-absorber

Remove a spring together with the lower cup (fig. 4.39).

ATTENTION If the top cup of a spring was disconnected from a nest, replace it.

Install the lower cup of a spring on a beam of a back suspension bracket (correctly arrange a guide).

Establish a spring together with the top cup in the situation noted earlier, since top.

Establish a hydraulic jack with a wooden lining under a spring cup.

For a preliminary inhaling of a bolt of the lower fastening of the shock-absorber squeeze a back suspension bracket.

ATTENTION The final inhaling of bolts of fastening of the shock-absorber is made when the car costs on wheels.

Remove a hydraulic jack.

Establish a back wheel.

Lower the elevator and put the car on wheels.

Tighten the required moment 105 N · m a bolt of the lower fastening of the shock-absorber and wheel bolts.