Install the car on the two-rack-mount elevator.

Disconnect the rechargeable battery.

Remove protection of the pallet of a case of the engine.

Take off a belt of the drive of auxiliary units.

Fig. 2.41. Installation of special devices

Install special devices (Mot. 1453 and Mot. 1453-01) with the holding belts (fig. 2.41).

Fig. 2.42. Drawing tags on support of a pendular suspension bracket

Note the provision of a support of a pendular suspension bracket concerning a body (fig. 2.42).

Remove a support of a pendular engine mount assembled with the top arm.

Remove the lower jet draft.

ATTENTION You watch to damaging the conditioner pipeline.

Remove bolts of fastening of the muffler of noise of an admission.

Remove the muffler of noise of an admission.

Pierce on the center of a cap of camshafts the screw-driver.

Remove caps of camshafts screw-drivers.

Fig. 2.43. Location of a stopper of an opening under VMT clamp: 1 – stopper

Remove an opening stopper under a clamp of VMT (fig. 2.43).

Fig. 2.44. Installation of a clamp of VMT: 1 – grooves of camshafts; 2 – VMT clamp

Arrange grooves of camshafts horizontally and with shift from axes of shaft down, turning a bent shaft in the direction of rotation (clockwise if to take a detached view the GRM drive) (fig. 2.44).

Screw VMT clamp (Mot. 1489).

Fig. 2.45. Provorachivaniye of a bent shaft clockwise

Turn a bent shaft clockwise (if to take a detached view the GRM drive) against the stop in a clamp of VMT (fig. 2.45).

Make sure that grooves at end faces of camshafts are located horizontally and below axes of shaft.

Fig. 2.46. Verification of the provision of grooves at end faces of camshafts

Fig. 2.47. Removal of a pulley of a bent shaft, top and lower cover of the GRM drive: 1 – pulley of a bent shaft; 2 – top cover of the GRM drive; 3 – lower cover of the GRM drive

Remove a pulley of a bent shaft, having blocked a flywheel the screw-driver, the top and lower covers of the GRM drive (fig. 2.47).

Fig. 2.48. Removal of a bypass roller by means of special adaptation: 1 – nut of fastening of an axis of a tension roller; 2 – bypass roller

Having released a nut of fastening of an axis of a tension roller, weaken a tension belts of the GRM drive (fig. 2.48).

Shoot bypass a video by means of special adaptation.

Take off a GRM drive belt, watching that the cogged pulley of a bent shaft did not fall.

Remove the cogged pulley of a bent shaft.

Shoot a tension video.