7.6.1.4. On-board computer
The data controlled by the on-board computer are displayed instead of run meter readings when pressing the ADAC button (management of a conclusion of data to the display of the on-board computer) located at a screen wiper switch lever end face. The counter of a daily run is nullified by pressing the RAZ button (Zeroing).
Information of the on-board computer is consistently output to the display after indications of the counter of a run for a trip in a certain sequence.
Fuel consumption (in liters) from the moment of the last zeroing.
Average fuel consumption (in l / 100 km) from the moment of the last zeroing.
This message appears on the display only after the car passes about 400 m, from a start of motion.
It considers the passable distance and the amount of fuel spent from the moment of the last zeroing.
The current fuel consumption (in l / 100 km).
This indication appears on the display at a speed of movement over 30 km/h (approximately).
At completely released pedal of an accelerator and speed of the movement higher than 30 km/h the current fuel consumption is equal to "zero".
Expected run before the following fuelling (in km).
This message appears on the display only after after a start of motion the car passes about 400 m, from a start of motion.
It is about the potential stock of the course calculated on the basis of the passable distance, amount of fuel in a tank and fuel consumption.
At the burning alarm lamp of the emergency rest of fuel the course stock on fuel is not displayed.
The distance passed from the moment of the last zeroing (average speed of the movement from the moment of the last zeroing).
This message appears on the display only after the car passes about 400 m, from a start of motion.
Average speed pays off division of the passable distance into time which passed from the moment of the last zeroing.
All calculations are made by the on-board computer.
The course stock to an ocherednoizamena of oil shows to the driver distance (in km) which can be passed before the following replacement of oil.
The set speed of the movement.
If the car is equipped with the regulator and the limiter of speed, on the display the preset value of speed in (km/h) is displayed.
At each change of a preset value of speed or in cases when this value cannot be sustained, this information replaces information chosen as the on-board computer.
|
ATTENTION
If the on-board computer highlights the blinking symbols dashes, means malfunction is found.
|