7.3.13. Removal and installation of the sensor of height of the proofreader of headlights of a back part of a body
Removal
Separate the socket.
|
Fig. 7.27. Removal of a stopper of the sensor: 1 – stopper
|
Remove a stopper (fig. 7.27).
|
Fig. 7.28. Removal of a bolt of fastening of the sensor: 1 – bolt
|
Turn off a bolt of fastening of the sensor of height of a back part of a body (fig. 7.28).
Installation
Install the sensor with an arm on the car.
Tighten the required moment 8 N · m a bolt of fastening of the sensor of height of a forward part of a body.
|
ATTENTION
Surely replace a stopper after each removal.
|
|
NOTE
The sensor of height of a forward part of a body you differ according to the electronic characteristics from the sensor of height of a back part of a body therefore it is very important not to mix them.
The tag of green color is applied on the sensor of height of a back part of a body.
|
Execute calibration of EBU.
Adjust a fary.