Fig. 8.2. Check of control points of a body of the car

Check by comparison of the left and right parties symmetry of a back control point in relation to a lobby of a control point, see an example in the figure 8.2: G – B3G = GG – VZ MG-B1G = GG-B1

Check by comparison of the left and right parties symmetry of points in a blow zone, see an example in the figure 8.2: VZ – JG = B3G – J.

If symmetry of the parties of the car is broken, it is necessary to check the sizes specified in the corresponding repair manual of the car.

NOTE Openings under the bottom of a body are closed by plastic caps for ensuring tightness of the hidden cavities. When checking by comparison of diagonals it is necessary to remove some of these caps. In case of damage of caps surely replace them new to ensuring protection of the car against corrosion.