Protect an upholstery (for example, a knife for removal of mastic).

Fig. 8.51. Removal of the panel of the switch of a window regulator

Disconnect the window regulator switch panel (in a back part) nippers for removal of holders of upholsteries and facings (fig. 8.51).

Fig. 8.52. Removal of the holder in ware office

Remove holders in ware office (fig. 8.52).

Enter a hand against the stop into a bottom of ware office.

Fig. 8.53. Shift of ware office in the direction to an internal part of a box of a door

Displace ware office in the direction to an internal part of a box of a door to a detachment of office (fig. 8.53).

Fig. 8.54. Extraction of ware office

Take out ware office from a nest (fig. 8.54).

ATTENTION Do not pull for a cover of a ware box.

Fig. 8.55. Removal of an overlay of the handle of an armrest

Disconnect an overlay of the handle of an armrest (fig. 8.55).

Separate the socket of the switch of an external rear-view mirror.

Unscrew screws of fastening of the switch.

Uncover.

Fig. 8.56. Removal of the internal handle of a door

Turn off the screw of fastening of the internal handle of a door (fig. 8.56).

NOTE Do not take a cable of the drive of the internal handle of a door.

Fig. 8.57. Removal of the hatch of an upholstery of a door

By means of nippers for removal of holders of upholsteries and facings disconnect the door upholstery hatch (having taken measures not to damage an upholstery) (fig. 8.57).

Open the hatch.

Enshrine the hatch in the open provision by an adhesive tape.

Remove the lock cylinder.

Fig. 8.58. Detachment of a fork part of the socket of the button of turning on of the lock

Disconnect a fork part of the socket of the button of turning on of the lock (fig. 8.58).

Fig. 8.59. Removal of the external handle of a door

Disconnect a rozetochny part of the socket from the handle and take its (fig. 8.59).

Fig. 8.60. Final detachment of the handle of a door

Disconnect the handle, trying not to damage the socket (fig. 8.60).

Fig. 8.61. Verification of laying of the handle: 1 – laying

Before installation of the handle check existence of laying (fig. 8.61).

Fig. 8.62. Installation of the handle and cylinder of the lock: 1 – lock cylinder; 2 – locking level

Install the handle, the cylinder of the lock and block its locking level (fig. 8.62).

Check manually operation of the cylinder of the lock.

Installation is made as it should be, the return to removal.